Title: Plumbers, Gas Fitters and Electricians VariationRegulations 2004
Subject: Plumbers, Gas Fitters andElectricians Act 1995
Author: Office of Parliamentary Counsel
Category: public
Document comments: 198

No 198 of 2004 published in Gazette 9.9.2004 p 3618

Plumbers, Gas Fitters and Electricians Variation Regulations 2004

Plumbers, Gas Fitters and Electricians Variation Regulations 2004
Part 1—Preliminary

Plumbers, Gas Fitters and Electricians Variation Regulations 2004
Preliminary—Part 1

Plumbers, Gas Fitters and Electricians Variation Regulations 2004
Part 2—Variation of Plumbers, Gas Fitters and Electricians Regulations 1995

Plumbers, Gas Fitters and Electricians Variation Regulations 2004
Variation of Plumbers, Gas Fitters and Electricians Regulations 1995—Part 2

South Australia
Plumbers, Gas Fitters and Electricians Variation Regulations 2004
under the Plumbers, Gas Fitters and Electricians Act 1995

Contents
Part 1—Preliminary
1	Short title
2	Commencement
3	Variation provisions
Part 2—Variation of Plumbers, Gas Fitters and Electricians Regulations 1995
4	Variation of regulation 3—Interpretation
5	Variation of regulation 4—Exemptions

Part 1—Preliminary
1—Short title
These regulations may be cited as the Plumbers, Gas Fitters and Electricians Variation Regulations 2004.
2—Commencement
These regulations come into operation on the day on which they are made.
3—Variation provisions
In these regulations, a provision under a heading referring to the variation of specified regulations varies the regulations so specified.

Part 2—Variation of Plumbers, Gas Fitters and Electricians Regulations 1995
4—Variation of regulation 3—Interpretation
Regulation 3(1), definition of contract of training—delete "Industrial and Commercial Training Act 1981" and substitute:
Training and Skills Development Act 2003
5—Variation of regulation 4—Exemptions
	(1)	Regulation 4(1) and (2)—delete subregulations (1) and (2)
	(2)	Regulation 4(5)—delete subregulation (5)
	(3)	Regulation 4(6)(a)(i)—delete subparagraph (i) and substitute:
	(i)	consisting of the installation, alteration, repair, maintenance or disconnection of a cold water pipe—
	(A)	not exceeding 25 mm in diameter (except where the pipe is in or on a building); or
	(B)	if the pipe is used for the purpose of irrigation and is situated, or is to be installed, downstream from a testable backflow prevention device;
	(4)	Regulation 4(6)(c)—before subparagraph (i) insert:
	(ai)	relating to electricity infrastructure owned or operated by an electricity entity that is required by condition of licence, or by the regulations, under the Electricity Act 1996 to have a safety and technical management plan;
Note—
As required by section 10AA(2) of the Subordinate Legislation Act 1978, the Minister has certified that, in the Minister's opinion, it is necessary or appropriate that these regulations come into operation as set out in these regulations.
Made by the Governor
with the advice and consent of the Executive Council
on 9 September 2004
No 198 of 2004
CS0018OCBA